User Manual

14
* These menus are related to other settings. They are not visible unless related settings are enabled
*1 “Standby Test Time” is shown depending on the setting of “Standby Test” in the CONFIGURE Menu.
*2 “Boost Hold Time” is shown in pressure mode when “Standby Test” (in CONFIGURE Menu) is set to
Boost.
*3 If “Stop Time” is before “Start Time” then the Backup will run through midnight. Start Time is hidden if
Stop Time is disabled.
*4 “Fallback Delay” is shown if “JP Fallback” setting is “On” in the CONFIGURE Menu.
Sub Menu
Units
Range
Defaults
TIMING
Lo Press Delay seconds
Off,
0 - 250
120
Hi Press Delay seconds
Off,
0 - 250
4
In Delay Timer seconds 0 - 999 4
Out Delay Timer seconds 0 - 999 1
Restart Delay seconds 0 - 999 0
*1 Standby Test Time seconds 0 - 999 10
*4 Fallback Delay seconds 0 - 999 10
*2 Boost Hold Time seconds
Off,
1 - 250
15
Pump Fault Timer seconds 0 - 250 10
No Flow Delay seconds 0-250 10
I/P Delay Timer seconds 0 - 999 120
* Press Trip Low Delay seconds 0 - 999 0
* Press Trip High Delay seconds 0 - 999 0
* Flow Trip Low Delay seconds 0 - 999 0
* Flow Trip High Delay seconds 0 - 999 0
*3 Stop Time (24hr) HH:MM Disabled, 0:00 -> 23:59 Disabled
*3 Start Time (24hr) HH:MM 0:01 -> 00:00 0