Classic Heater Pool Controller Installation and Operating Instructions Please pass these instructions on to the operator of this equipment.
INSTALLATIONS INSTRUCTIONS — PLEASE READ CAREFULLY GENERAL The spa heater is the first of a new generation of heaters that have been totally redesigned to incorporate all the latest concepts in safe water heating. The heater is reliable, easy to install, simple to operate and easy to maintain. It includes all its own control and safety devices. It is designed to look after itself. All the control system of the spa pack has to do is turn on the pump.
WIRING ALL FIXED ELECTRICAL WIRING MUST BE COMPLETED BY A SUITABLY QUALIFIED PERSON. 1. Check the kilowatt rating of the heater. Ensure the correct size cable is being used. 2. The cable entry point is via one of three knockouts provided on the underside of the heater head. Use the correct size grommets and conduits when installing. 3. Check that wiring to terminal blocks is secured firmly and to the correct terminals. PLUMBING 1. The heater body may be plumbed so the water flow can be in either direction.
TESTING (MUST BE COMPLETED BY QUALIFIED PERSONNEL) 1. Double check that all plumbing is connected correctly and that the supply is available for heater and control box. 2. Before switch on check that gate valves (if fitted) are open and the thermostat is turned fully anti clockwise. 3. The heater lid should be off for setting up pressure switch adjustment. 4. Apply a voltmeter, neon indicator or such test device at element terminal or control relay. If preferred, a current meter could be used. 5.
Turn the screw clockwise if the pressure holds heating element on. Turn anticlockwise if the pressure is insufficient to operate the heater. The above adjustments can only be done if the pool is below the thermostat setting. The ‘O’ ring must be fitted to the control head against the retaining edge before fitting to heater body. Do not rely on locking ring to pull head and body together. Use downward pressure while tightening locking ring, making sure that locators engage correctly. Hand tighten only.
NOTES 6
Davey® Repair or Replacement Guarantee In the unlikely event in Australia or New Zealand that this Davey product develops any malfunction within two years of the date of original purchase due to faulty materials or manufacture, Davey will at our option repair or replace it for you free of charge, subject to the conditions below. Should you experience any difficulties with your Davey product, we suggest in the first instance that you contact the Davey Dealer from which you purchased the Davey product.
AUSTRALIA NEW ZEALAND Davey Support Centre 6 Lakeview Drive, Scoresby, Australia 3179 Ph: 1300 367 866 Fax: 1300 369 119 Website: davey.com.au Davey Support Centre 7 Rockridge Avenue, Penrose, Auckland 1061 Ph: 0800 654 333 Fax: 09 527 7654 Website: daveynz.co.nz Davey Water Products Pty Ltd Member of the GUD Group ABN 18 066 327 517 ® Davey is a registered trade mark of Davey Water Products Pty Ltd. © Davey Water Products Pty Ltd 2013.