Owner manual
IMPORTANT
®
may only be legally
installed by a licensed plumber.
change etc. can cause the
pump and tank to move slightly
relevant to the home it is highly
recommended that discharge and/
or suction pipe lines be fitted with
hose, reinforced suction hose or
polythene pipe.
Different types of RainBank
®
Installations
®
can
be installed depending on your rainwater
tank and pump configuration.
INSTALLATION TYPE 1 - PAGE 16
Tank: above ground
Pump: outside tank
Float switch: must be installed inside
of tank
Pump Kit:
INSTALLATION TYPE 2 - PAGE 21
Tank: above ground
Pump: submersible inside tank
Float switch: incorporated with pump
Pump Kit:
INSTALLATION TYPE 3 - PAGE 22
Tank: below ground
Pump: submersible inside tank
Float switch: incorporated with pumps
Pump Kit:
Mains In
To
House
Mains In
To House
FS
7
1. Pump not plugged in.
®
®
into power supply.
2. No power supply to pump.
restored.
3. Float switch not connected to
RainBank
®
.
®
®
confirm the connection is correct,
pump will start.
4. No water in tank.
5. Float switch located at water
tank is installed incorrectly.
6. Mains water supply not
connected to RainBank.
®
system must have a
pressurised water supply connected to
button to simulate mains water
7. Mains supply to RainBank
®
turned off.
button to simulate mains water
is available.
8. Pump is faulty.
pump, plug the pump directly into
power point and check to see if it
®
and
does not start contact your supplier for
further advice.
9. Lead from oat switch to pump
broken or damaged.
10. Float switch defective.
advice.
11. Mains water ow is too low.
above 5 litres per minute.
SYMPTOM: PUMP WILL NOT SWITCH ON
®
Mains In
To
House