Owner manual

 
is not properly orientated. Make
 
 
 
 
 
 
visible, screw on and tighten the
sealing nut to finish the installation of
 
STEP 4 - CHECK PIPE WORK
Make sure the final assembled position

®
will align well with the
mains and rainwater pipe.

®
should be
assembled so that the mains water
supply to the unit and rainwater outlet to
toilets and laundry connect easily to the
plumbing on the same level.
STEP 5 - CONNECT PUMP TO
RAINBANK
®

®
 

STEP 6 - CONNECT PIPES

®
to the mains water
and delivery pipe plumbing.
IMPORTANT
 
 
copper pipes that allow some
movement so that they can line
 
 
 
Tighten Sealing Nut
Insert Float
Drill Hole
ø 22mm

18 19
‘UP’
Tighten Compression Nut

inside tank
 
 
or very thick plastic walled tanks.
 
that can be lowered into the top of
 
 
Work out the correct position for

corrugated profile tank wall this is

as shown below.

switch relative to the pump outlet.

 
 
 
does not interfere with the operation
of the switch.



®
and plug
comfortably into it.
1. Drill a 22mm hole in the side of the
 
drill is the best tool for this job.
 
 
corrugated tank you should make sure
 
between the radii as shown below.
 
loosened so that the sealing grommet
 
nut and insert the switch into the hole
as below.
Centre hole on flat section of profile
Diameter of hole must be 22mm.
Note: Ensure level sensor is installed
with ‘UP’ facing up
150
40
100
Slab
To
Pum
p