Owner manual



®
or
its pump we strongly recommend the use
of a suitable surge protection device and
residual current devices.
STEP 8 - TESTING

®
.
1. With the mains connected and the
rainwater tank empty turn on one
of the taps in the laundry that feed
 
 
 not turn
 ‘status’ light should glow
‘red’ to indicate that mains water is
being used. When this is completed
turn off tap.
2. Fill the rainwater tank with sufficient
 
switch.
 
primed and there are no air locks that
will interfere with its operation as per
 
essential for the proper operation of
 
to do this for all types of Davey pump
 
 
 
should run and deliver rainwater.
 
 ‘status’ light
will now glow ‘green’.
 
 
®
– this should
stop the pump and confirms that
 
connections have been made correctly
 
‘status’ light will now glow ‘red’.


‘status’ light will glow ‘yellow’
while the manual override button is
depressed.


®

models.
 
®
, the
pump, pipework and fittings.
INSTALLATION TYPE 2
Above ground tank with submersible
pump inside eg: KRBS1&2
IMPORTANT
 
 
level so it is not necessary to drill the
 
Mains In
To
House
16 21
INSTALLATION TYPE 1
Above ground tank and pump
outside tank. Suitable kit models:
KRB1,2,3&4

 
 
 
 
 
 
 
 
®
to a wall as a bare installation you
 
®
wall
mounting bracket
 
STEP 1 - PUMP POSITION




of the tank to avoid sludge being drawn
into the pump.



STEP 2 - RAINBANK
®
POSITION

®
will be
positioned.

reach of the 3 metre power lead.
IMPORTANT

leads as they cause substantial voltage
drop, poor performance and can lead to
motor overload.


®
.


Mains In
To House
FS

Installation Inside Buildings
cater for possible plumbing leaks or damage

®
system components, the
installation must include an enclosure that will
capture any water spraying from the plumbing

®
system and direct it into a
properly constructed drain tray.

Note
®
and/or associated pump system inside a
building, allowance for possible high pressure


Note

®

accessible to the end user or home owner.