Owner manual

22 15
 
pump prior to connection of the pump
 
®
can cause an air lock
that may prevent the pump operating
properly.
The following sections of the Type
1 installation instructions are
applicable to Type 2 installations.
Step 2 – Work out the position of your

®
with regard to distance to

issue here.
Step 4
®
for easy
fitting to the plumbing and fit Davey wall
bracket if required.
Step 5
®
to your
submersible pump as per instructions on
page 25.
Step 6
®
to the

page 19.
Step 7


submersible pump.
Step 8
INSTALLATION TYPE 3


IMPORTANT
 
collecting/storing rainwater in a
partially buried tank is considered
 
 
®

 
to fit additional
valves to satisfy this requirement –
check with your local council as to
their guidelines on rainwater tank
 
 
switch as this comes attached to the
submersible pump and does not plug
 
®
unit.



TO TOILETS
AND/OR
LAUNDRY
(do not mix/cross-connect
with mains water supply)
MAINS
WATER SUPPLY
3/4" BSP M
RAINWATER
SUPPLY
from discharge of auto submersible rainwater pump
Power to pump via 3 pin socket - plug the rainwater pump in here.
Incoming power
to RainBank
®
via 3 pin plug
3/4" BSP M
1" BSP M
Stop valve
200 Micron ‘Y’ Strainer
* Pressure Limiting Valve
WHERE MAINS PRESSURE EXCEEDS 900kPa. A PLV* MUST BE FITTED TO INLET!
Mains In
To
House
WARNING: DO NOT INSTALL CHECK VALVES BETWEEN PUMP AND RAINBANK
®
.
IMPORTANT: ALL PIPEWORK AND OUTLET FITTINGS FROM RAINBANK
®
MUST BE LA-
BELLED TO AS3500. DO NOT CONNECT WITH CRIMPED FITTINGS.