Owner's manual

6 3
Weather Protection
It is recommended that the pump is protected from the weather.
Power Connection
Davey QB Series are suitable for connection to a nominal 240 volt 50Hz power supply and are
equippedwithaexleadand3pinplugorAMPplugtoallowconnectabilitytoaDaveySpa
controller.Ifapoweroutletisnotavailablewithin3metresofthepump,a3pinpowerpoint
inasafe,dryplace,mayneedtobeprovidedbyanelectrician.Extensioncordsareunsafe
aroundpoolsorspas-andshouldbeavoided.Ifthesupplycordofthisproductisdamagedit
mustbereplacedbythedealerormanufacturer,withgenuineDaveyspares.
Pipe Connection
Asetofbarrelunionsareprovidedforconnectingtothepipingfromthespaorpool.
Thepumpsaredesignedtoaccept50mmPVCpipesbyttingthepipetotheinsideofthe
union tail.
The use of any pipe smaller than 50mm PVC pressure pipe not recommended. Suction piping
shouldbefreefromallairleaksandanyhumpsandhollowswhichcausesuctiondifculties.
The suction and discharge pipe should have a constant gentle slope of at least 2% to facilitate
adequate purging of air.
If the pump and lter are located below pool water level, it is necessary to
t isolating valves in the pipe between the pump and the skimmer box or
suction inlet and in the return pipe from the lter to the pool.
Warning! Ensure that an electrical isolation switch is located with easy
access so that the pump can be switched off in an emergency.
CAUTION:
In the interest of safety, we advise that all brands and types of spa pool
pumps must be installed in accordance with AS3000 wiring rules or equivalent
Davey Water Products recommends that all installations are tted with
earth leakage or residual current protection devices.
This pump is not to be used by children or inrm persons and must not be
used as a toy by children.
Barrel unions need to be hand tightened. No sealant, glues or silicones
are required.
Pump Dimensions