Manual

10
(2) Models with Analogue Timer
IfyourPowerSupplyisttedwithananaloguetimeclocktheoperatingtime(s)canbeeasilysetbypushingthe
smallpinsforwardorbackwardstothedesiredoperatingtime(s).Theunitcomespre-setfor8hoursoperationper
day.TheON-OFF-AUTOswitchfunctionsasfollows:
On- Over-ridesautomatictimeclock,FiltrationSystemswitchedon.
Off- Over-ridesautomatictimeclock,FiltrationSystemswitchedoff.
Auto- FiltrationSystemswitchesonandoffautomaticallyaccordingtotimesset.
OPTIONAL POOL LIGHT TRANSFORMER:
Power connections and wiring must be carried out by an authorised electrician.
Your Davey ChloroMatic
®
isttedwithoneoftwotypesofpoollighttransformerconnectionsasfollows:-
TYPE 1: TERMINAL BLOCK CONNECTION BEHIND COVER PANEL BELOW DOOR
(a) 12V – Operates only 12 volt lights.
TakeoffCoverPanelbelowDoorbyremovingthetwoself-tappingscrewsatbottom.
•12Vconnections:
- InsertthetwowiresfromyourpoollightintoeitherofthewireterminalsoftheTerminalBlockprovided.
Fasten screws.
•Multi-voltageconnections:
- Refertotableanddiagrambelowforwiringinstructions.
Please Note: Only one light can be connected to each light transformer. If more than one light is required
please refer to your ChloroMatic
®
dealer.
TYPE 2: BLACK & RED TERMINAL SOCKET IN BASE OF UNIT
This terminal socket may accept light connection in two ways:
• “Banana”plugsintothebottomoftheterminal
• Wiresintotheterminalholesatrightangles,andfastenedbyscrew
SAFETY NOTICE
IMPORTANT Certain local electrical regulations state “If the supply cord is damaged, it must be replaced
by a special cord available from the manufacturer or its service agent”.
MAINTENANCE OF POWER SUPPLY:
Little or no maintenance is normally required with the exception of replacing blown Fuses. These Fuses can be
sourced from your local ChloroMatic
®
Dealer. However it is essential that the wall or post to which the Unit is
installed be sprayed (not the Unit itself) periodically with a good surface type insect repellent, since penetration by
insects may cause damage, which is not covered by your warranty.
The back of the Unit has been designed as a heat sink. It is normal for this area to become very hot.