User guide

2.3! Midi Setup

In order for the Tetra SoundEditor software to communicate with the Tetra hardware, the hardware

must be connected to both the MIDI In and MIDI Out connections of your computer's MIDI

interface or through the USB port. If these connections are not already in place, shut down the

computer (always a good idea before connecting/disconnecting anything!) and connect the

interface, the MIDI In and MIDI Out cables or the USB cable to the hardware.

With the proper connections between the Tetra and the MIDI interface or USB cable in place,

reboot and launch the SoundEditor program. Click on the MIDI menu and select MIDI Setup.

You’ll see the following window (your window may show different port information):

! Select the Midi Port Connections tab. Highlight the ports that your Tetra is connected to the

hardware. Select the DSI Tetr4:DSI Tetr4 ports if using the USB connection

Select the Midi In - Keyboard Controller to set the parameters for the Midi In port.

Tetra SoundEditor User Guide Page 9