User guide

7.5 ! Librarian Toolbar
The Librarian Toolbar (below) provides convenient access to frequently-used Librarian
! commands and functions. Descriptions of each Toolbar button follows.
The Add Current Program button adds the current Program from the User Bank to the active
sound category. Note that new entries are always added to the end of the list, so if you have a lot of
Programs in a particular category, you may have to scroll down to see the new entry.
! The New button allows you to create a new Library. After selecting New, you will get a message
dialog box asking if you wish to save the existing library. To save the existing Library, clicking the
OK button in the message box will present you with a ‘Save As...’ window where you can name
and save the current Library file to the specified storage location. After the ‘save’ operation is
complete, you will have an empty (new) Library. If you decline to save the existing Library, the
contents of the existing library (all 32 categories) will be cleared, leaving an empty Library.
! The Save button allows you to save the current Library. Selecting Save produces a ‘Save As...’
window where you can name the Library File and select the storage location for the fi le.
! The Load button allows you to load a library file into the Librarian. Loading a library file is just
like loading a bank file, but with a difference – library file names have the extension .m_l.
!
! The Add Current Program, New, Save and Load buttons duplicate commands found in the
menus.
! Finally, although not part of the operational controls described above, the Edit button takes you to
the Controls Window, where you can edit the Library’s currently selected Program.
You can load a new library into an existing library to combine the presets of each. You can also combine presets from
different banks using the ‘Load from User Bank Data’ command.
Tetra SoundEditor User Guide Page 37
You can load a new library into an existing library to combine the presets of
each.
You can also combine presets from different banks using the ‘Load from User
Bank Data’ command.