User Manual
69
Prophet X User’s Guide
Sequencer
6. To save the sequence, save the program by pressing the save/load
button twice.
Sequencer Parameters (Front Panel)
Record: On, Off—This switch turns sequencer recording/editing on and
off on the polyphonic sequencer.
Play: On, Off—This switch starts and stops polyphonic sequencer playback.
Additional Sequencer Parameters (Display Menus)
Additional sequencer parameters are found in the menus in the main
display. To see these, press the record button on the front panel.
CHORD NOTE
Chord Note NoteStep Velocity
STEP
1 C5 1001
VELOCITY
NOTE
Set LengthTie Rest
The Sequencer menu
Chord Note: 1...6—The sequencer can record up to 6 notes per step (i.e.,
a 6-note chord). The chord note parameter lets you select a specic note
within a chord for editing. Notes are listed from lowest to highest.
Step: 1...64—Selects a specic step within the sequence for editing.
Note: C0...C10—Sets the note value of the current step.
Velocity: 1...127, Rest—Sets the velocity of the current step. Turning the
knob fully clockwise sets the step to rest.
Tie—Pressing Soft Key 1 adds a tie to the current step.
Rest—Pressing Soft Key 2 adds a rest to the current step.
Set Length—Using Soft Knob 2 to navigate to a specic step then press-
ing Soft Key 3 resets the length of the sequence so that it will end after
the selected step.