User Manual

60 Effects Dave Smith Instruments
Effects Parameters (Front Panel)
Effect 1: Turns effect 1 on or off. On stacked or split sounds, enable the
edit layer b button to adjust effects for Layer B.
Effect 2: Turns effect 2 on or off. On stacked or split sounds, enable the
edit layer b button to adjust effects for Layer B.
Effect Type: Selects the effect type.
Select 1/2: Toggles between effect 1 and effect 2 for editing.
Mix: 0...127—Sets the balance between the processed (wet) signal
and unprocessed (dry) signal. Full left is completely dry. Full right is
completely wet.
Sync: On, Off—When a delay effect is chosen, this enables syncing of the
timed delay repeats (feedback) to the arpeggiator, sequencer, or MIDI clock.
When
clk sync is on, delay time (parameter 1) has the following values:
Value Delay Time
Whole 4 beats
Half dot 3 beats
Half 2 beats
Quarter dot 1 1/2 beats
Quarter 1 beat
Quarter triplet 1 1/3 beats
8th dot 3/4 of 1 beat
8th 1/2 of 1 beat
8th triplet 1/3 of 1 beat
16th dot 3/8 of 1 beat
16th 1/4 of 1 beat
Maximum delay time is 1 second. The combination of longer synced delay
times with slower tempos can result in delay times that would be greater than 1
second. When that happens, the delay time is divided by 2 until it no longer exceeds
the 1 second limit. For example, if the BPM is set to 60 and Delay Time (Parameter 1)
is set to Half, the expected delay time would be 2 seconds. The actual delay time will
be 1 second (i.e. 2 seconds divided by 2).