User Manual

115
Prophet X User’s Guide
Rear Panel Connections
1 3 4 5 62 7 11
VOLUME
8
PEDAL/CV
MAIN A OUTPUT
9 10
B OUTPUT
SAMPLE IMPORT
PROPHET
Prophet X Rear Panel
4. MIDI In, Out, and Thru—Standard 5-pin MIDI DIN connectors.
5. Sequencer—Accepts a momentary, normally open or normally closed
footswitch to turn the sequencer or arpeggiator on and off. Alternatively,
an audio signal connected to this jack can be used to either control
sequencer/arpeggiator playback, or to gate the lter and amplier enve-
lopes while notes are held. See Seq Pedal Mode on page 127 for more
information about choosing the appropriate mode for these behaviors.
Audio signals used to drive the arpeggiator/sequencer should not exceed 5
volts peak-to-peak.
6. Sustain—Accepts a momentary, normally open or normally closed
footswitch to control sustain.
7. Volume—Accepts a standard expression pedal that has a variable
resistor on a TRS (tip-ring-sleeve) ¼ inch phone plug. Once connected,
you can use the modulation matrix to route the pedal to control a variety
of things such as volume or lter cutoff frequency to add expressiveness
to live performance.
8. Pedal/CV—Accepts a standard expression pedal that has a variable
resistor on a TRS (tip-ring-sleeve) ¼ inch phone plug. Once connected,
you can use the modulation matrix to route the pedal to control a variety
of things such as volume or lter cutoff frequency to add expressiveness
to live performance.