User Manual

93
Prophet X User’s Guide
Creating a Hard-Sync Lead
5. Enable the sync 2>1 button. (See “Sync 2>1” on page 24 for an
explanation of phase sync.)
6. Set the pitch of Oscillator 1 to C3. This will intensify the sync effect.
7. In the auxiliary envelope section, select envelope 3 and set its desti-
nation to osc1 freq. This routes envelope 3 to modulate osc 1 pitch
according to its ADSR (attack, decay, sustain, release) settings.
8. Set the auxiliary env amount to 127 and attack to 23, decay to 60,
sustain to 100, and release to 65. This will set the amount and “shape”
of the modulation.
9. Play some single notes and in the middle range of the keyboard. Clas-
sic hard-sync lead!
10. To make it a little edgier, set lter drive to 100, lter cutoff to 0, lter
envelope decay to 100, and lter env amount to 127.
Adding Effects to the Lead
You can enhance the sync lead by adding some delay and reverb.
To add effects:
1. In the effects section, press the effect 1 button.
2. Turn the effect type knob and select delay stereo.
3. Set mix to 22, then set parameter 1 (time) to 135, parameter 2 (feed-
back) to 47, and parameter 3 (lpf) to 100.
4. In the effects section, press the effect 2 button.
5. Turn the effect type knob and select super plate.
6. Set mix to 47, then set parameter 1 (time) to 100, parameter 2 (tone) to
138, and parameter 3 (predelay) to 12.
7. Play some notes. Searing hard-sync lead!