User Manual

41
Prophet Rev2 User’s Guide
Arpeggiator
Arp Repeats: 1, 2, 3 —Set to 1, each note in the arpeggio plays once.
Set to 2, each note in the arpeggio plays twice. Set to 3, each note in the
arpeggio plays three times.
Arp Relatch: Off, On—Works in conjunction with hold. When hold and
the arpeggiator are on, and arp relatch is off, played notes are held on
and arpeggiated, with additional played notes added to the held notes
and the arpeggio. When
arp relatch is on, played notes are held on and
arpeggiated, but additional played notes will restart the arpeggio with the
new notes.
Clock Parameters
BPM: 30…250—Sets the tempo for the arpeggiator in BPM (beats per
minute). The
tap tempo LED ashes at the BPM rate. When lfo sync is
enabled on the low-frequency oscillator, or clk sync is enabled in the Effects
section, the BPM rate affects the LFO frequency and/or delay effect. When
syncing to an external MIDI clock source, the BPM setting has no effect.
Divide—Selects a basic note value relative to the BPM. See the table below:
Name Tempo Timing Division
Half BPM/2 Half note
Quarter BPM Quarter note
8th BPM x 2 Eighth note
8 Half BPM x 2 Eighth note, half swing timing
8 Swing BPM x 2 Eighth note, full swing timing
8 Trip BPM x 3 Eighth note triplets
16th BPM x 4 Sixteenth note
16 half BPM x 4 Sixteenth note, half swing timing
16 Swing BPM x 4 Sixteenth note, full swing timing
16 Trip BPM x 6 Sixteenth note triplets
32nd BPM x 8 Thirty-second note
32 Trip BPM x 12 Thirty-second note triplets
64 Trip BPM x 16 Sixty-fourth note triplets
Tap Tempo—
Tapping the tap tempo button sets the tempo. The LED
ashes at the BPM rate you set. For best results, tap the button 4 times.