User Manual

33
Prophet Rev2 User’s Guide
Modulation
Modulation Parameters
Source: Selects a modulation source. The are twenty-two different
modulation sources. See page 69 for a complete list.
Destination: Selects a modulation destination. The are fty-three differ-
ent modulation destinations. See page 70 for a complete list.
Amount Sets the modulation amount. Modulation can be either positive
or negative.
Modulation Examples
Below are several modulation scenarios that illustrate how to use the modu-
lation matrix. The examples provide full, step-by-step instructions for clarity.
In actual practice, there are shortcuts for routing modulation to various
front panel sources/destinations. Simply hold down the
source button
and move the control you want to use as a source (the mod wheel, for
example). Then hold down the destination button and move the control
that you want to use as a destination (lter cutoff, for example). Set
the amount using the parameter and value knobs next to the display.
Be aware that not all front-panel controls can be used as a modulation
sources/destinations.
To use the mod wheel to add vibrato:
1. In the low frequency oscillators section, set LFO 1 to triangle and
set frequency to 75. Set destination to osc all freq. Set amount to 0.
(You will control the amount with the mod wheel.)
2. In the modulation section, press the source button. Use the param-
eter knob next to the display to scroll to Mod Slot 1 if it’s not already
displayed.
3. Use the parameter knob to select the source eld. Use the value knob
to scroll through the various mod sources and choose mod wheel
4. Use the parameter knob to select the amount eld. Use the value knob
to set the amount to 30.
5. Use the parameter knob to select the dest eld. Use the value knob to
scroll through the various mod destinations and choose lfo1 amt.
6. Hold down a note on the keyboard and turn the mod wheel. You should
hear vibrato.