User manual

Soundtower Mopho PlugSE V1.1 3
MIDI Conguration
It isn’t practical to provide specic instruction in this document to cover all the possible MIDI interfaces or
congurations that are available. We will show an example of a typical MIDI conguration using a MIDIS-
PORT 2x2 MIDI interface.
NOTE: If you create a new MIDI track, the Mopho should appear as a possible input and output for MIDI
communication.
Click the MIDI button at the top of the Editor window. Select the
MIDI interface and port that the Mopho is connected to. Be sure
your MIDI input and output cables are correct. Once you have se-
lected the appropriate input and output ports, click the Poll button.
An ‘ON-LINE’ message will appear at the top of this window con-
rming proper connection.
MIDI FILTERS
• THRU:MIDIInCont.->MIDIOutPort
It enables to thru MIDI notes, continuous controller data, pitch
bend, aftertouch etc. to be passed to the MIDI port to which the
Mopho is connected.
• THRU:MIDIInPort->Host
Many Mopho programs are set to send notes and other MIDI data generated by the 16-step Sequencer through
the Mopho’s MIDI Out port. This feature was initially intended for Mopho to play other external MIDI devices,
however when used in connection with the PlugSE™ it may cause a MIDI loop. In order to prevent MIDI loops
this option should be set to OFF.
• THRU:Host->HostPlugSEMonitoring
This feature allows for the MIDI signal coming from the PlugSE™ track to be bounced to another host track.
• EnableProgramChangefromHost
If enabled, any program/bank change commands will be passed over from host to the Mopho resulting in a
program change.
For information about additional features found in MIDI Conguration panel please see MIDI section below.
Conrm Connections and Test
Editor/Hardware Interaction
Conrm that changes made using the PlugSE™ Editor affect the Mopho by adjusting a few controls in the Edi-
tor window; these changes should be reected on the Mopho hardware.
Record/Playback MIDI Data
Create a new MIDI track in your DAW. Select the MIDI interface port that the Mopho is connected to as your
MIDI destination. Record and playback a few test notes.