Specifications

10
Jump mode uses an absolute value based upon the position of the pot when
edited: turn a pot and the value jumps immediately from the stored value to the
edited value.
Sustain: Norm +, Norm -, Arp +, Arp - —A momentary footswitch connected to
Mopho x4’s Sustain input can be used either as a sustain pedal or to latch the
arpeggiator. Mopho x4 can be configured for use with either normally open (+)
or normally closed (-) footswitches. When set to Arp+ or Arp-, the footswitch
will act as a sustain pedal when the Arpeggiator is off.
Pedal: see table—Sets the destination for the Pedal/CV input. Note that this
input is heavily filtered for clean operation, so there is a limit to the speed it will
respond to changes.
Display
Pedal Routing
FootCtrl
Routed to the Foot Control Modulation
Breath
Routed to the Breath Control Modulation
Expressn
Routed to the Expression Modulation
Volume
Controls Master Volume
LpFilter
Routed to the low-pass filter
LpF Half
Routed to the low-pass filter, but with half the range
The input will also accept control voltages in the range of 0 to 3.3 volts DC. It is
protected against higher or negative voltages.
MIDI Pressure: Off, On—When On, the Mopho x4 will respond to received
MIDI pressure (aftertouch) messages and will transmit pressure from the
keyboard to MIDI Out.
Pressure Curve: 1…4—Sets one of the four pressure curves for the keyboard to
adjust the aftertouch to your playing style.
Velocity Curve: 1…4—Sets one of the four velocity curves for the keyboard to
adjust the velocity response to your playing style.
ArpLatch: Normal, ReLatch—Sets the arpeggiator latch behavior. See
Arpeggiator on page 27 for more information.
Basic Patch—Press the WRITE button to load a basic patch into the edit buffer.
The patch will not actually be written to the current program location unless
intentionally written to memory in program mode using the W
RITE button.
Reset Globals—
Select this parameter and press WRITE to reset the global
parameters to their factory defaults.