User guide

5
DSI Mopho SoundEditor - Introduction
6
DSI Mopho SoundEditor - Starting Up
2.
Starting Up
Set up the Mopho according to the Mopho Operation Manual (refer to the
Getting
Connected
section on page 3). Connect the Mopho to the your computer interface
Connected section on page 3). Connect the Mopho to the your computer interface Connected
using both MIDI In and MIDI Out connectors (both connections must be in place for
proper operation of the software).
After making the MIDI connections between the Mopho and your computer, power
up the Mopho and launch SoundEditor. As the SoundEditor program starts, a splash
screen will appear brie y.
If you are using the Light Edition of SoundEditor, the splash screen will be replaced by
the Controls Window (also referred to as the Main Window throughout this Guide). At
this point, users of the Light Edition should skip ahead to the
MIDI Setup
section on
page 8
.
If you are using the Pro Edition of SoundEditor, the splash screen will include a
‘Registration’ screen as shown below:
2.1
Getting Connected
This chapter describes the steps to connect and con gure SoundEditor on your computer.