User guide

DSI Mopho SoundEditor - Controls Window

5.2

Program Name Display

The Program Name Display (shown below) shows the name of the currently selected

Program (‘RetroMoPho’), the location of the Program (bank C, location 046), and the

category of the Program (‘Sequence’):

To change the Program name, double-click inside the Program Name Display. This will

produce a window where you can enter a new name (up to 16 characters in length), and

also select or change the Program Category, if desired:

Program names may include upper and lower case characters as well as

numbers and most punctuation marks.

Clicking on the

button will send the new name to SoundEditor and to the Mopho’s

OK button will send the new name to SoundEditor and to the Mopho’s OK

edit buffer, but will not automatically store the name. To store the new name you must

write the edited sound to the Mopho using the WRITE command.