Specifications

Mod Wheel Destination — Selects the destination to which the mod wheel is
routed. See Modulation Destinations on page 26 for a list of possible
destinations.
Press Amount: -127…+127 — Sets the maximum amount of modulation that
can be applied from MIDI Channel Pressure (aftertouch).
Press Destination — Selects the destination to which the Channel Pressure is
routed. See Modulation Destinations on page 26 for a list of possible
destinations.
Breath Amount: -127…+127 — Sets the maximum amount of modulation that
can be applied from MIDI Continuous Controller 2 (breath controller).
Breath Destination — Selects the destination to which the breath control is
routed. See Modulation Destinations on page 26 for a list of possible
destinations.
Veloc Amount: -127…+127 — Sets the maximum amount of modulation that
can be applied from MIDI note-on velocity.
Veloc Destination — Selects the destination to which the note-on velocity is
routed. See Modulation Destinations on page 26 for a list of possible
destinations.
Foot Amount: -127…+127 — Sets the maximum amount of modulation that can
be applied from MIDI Continuous Controller 4 (foot controller).
Foot Destination — Selects the destination to which the foot control is routed.
See Modulation Destinations on page 26 for a list of possible destinations.
Push It Switch Parameters
These parameters determine the behavior of the PUSH IT switch, Mopho’s
manual trigger.
Note: C0…C10 — Sets the note that plays when PUSH IT is pressed.
Velocity: 0…127 — Sets the MIDI note-on velocity.
Mode: Normal, Toggle, Audio In — When set to Normal, PUSH IT responds like a
key: press it and a note plays, release it and the note ends. But when set to
Toggle, P
USH IT turns the note on with one press and off with a second press.
This is handy for making a note drone or for latching a gated sequence on.
22