User's Manual


MTU Specify the Maximum Transmit Unit size. It is recommended you
accept the default setting of Auto. Otherwise, packets will be
fragmented downstream if the MTU is set too high or too low,
which impacts network performance. In extreme cases, an MTU
setting that is too low can prevent the OM2P-LC/OM2P-HS from
establishing some connections.
IP Address Enter the WAN port IP address. I P
Subnet Mask Enter the WAN IP subnet mask.
Gateway IP Address Enter the WAN gateway IP address.
PPTP Server Enter the IP address of the PPTP server.
Username Enter the username provided by your ISP.
Password Enter the password provided by your ISP.
Connect on Demand If you want the OM2P-LC/OM2P-HS to end the Internet
connection after it has been inactive for a period of time, select
this option and enter the number of minutes you want that period
of inactivity to last.
Keep Alive If you want the OM2P-LC/OM2P-HS to periodically check your
Internet connection, select this option. Then specify how often
you want the OM2P-LC/OM2P-HS to check the Internet
connection. If the connection is
down, the OM2P-LC/OM2P-HS automatically re-establishes your
connection
Get A u t o m a t i c a ll y
From I S P
Obtains the DNS automatically from DHCP server.
Use These DNS Servers Click the radio button to set up the Primary DNS and Secondary
DNS servers manually.
Discard Ping on WAN Check to Enable to recognize pings on the OM2P-LC/OM2P-HS
WAN interface or Disable to block pings on the OM2P-
LC/OM2P-HS WAN interface. Note: Pinging IP addresses is a
common method used by hackers to
test whether the IP address is valid. Blocking pings provides some
extra security from hackers.
Accept / Cancel Click Accept to confirm the changes or Cancel to cancel and
return previous settings.




Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see
section 4.1).