Service manual

DESCRIPTION
REAR
AXLE
The rear
suspension
is a
Banjo type
rigid
suspension
which uses a
parallel
semi elliptic leaf
spring
Both front
and rear ends of
the
spring
are secured on
the
frame
with
rubber
bushings
and
the
shock absorber
is
installed on the
cross member
from the
spring
lower
pad
The
suspension
type
is
an under slung type
SUSPENSION ASSEMBLY
Removal
I Jack
up
vehicle
and
support
it with
stands
Remove
road wheel
2 Disconnect
hand brake
wire a
equalizer
unit
and
separate
bracket
CD
3 Remove
brake tube
V
shock absorber
@
and
propeller
shaft
@
4
Support
axle case
with a
jack
at the center and
remove
spring pin ID
and shackle assembly
@
Note It is
not
necessary
to remove spring
seat from
shock absorber unless otherwise
required
5 Lower
jack
slowly
and remove
suspension
assembly
Fig
RA lJ
Removing
re4r
suspension
Fig
RA H
Removing suspension
assembly
SPRING
r
Removal
Jack
up
vehicle
support
it
with
stands
and remove
road wheel
2
Support
axle case with
jack
or stand
3
Remove V bolts
and
separate spring
from
axle case
Note
It is not
necessary
to remove
spring
seat from
shock absorber nless otherwise uired
4
Remove
spring pin
and
shackle
assembly
in the
manner identical
with removal
of
suspension
assembly
and remove leaf
spring
AXLE
CASE
Removal
1 Jack
up
vehicle
support
it with stands
and
remove
road wheel
2
Remove
hand
brake wire brake
tube
shock absorber
and
propeller
shaft
Remove U
bolts and
separate
axle
case
from
spring
r
3 Pass axle case
through space
above
spring
and take it
out to the side
RA 5