Service manual

CHASSIS
The front
suspension
is
a
double wishbone
type
in
dependent suspension
which
uses
torsion bar
spring
Both the
upper
and lower
links
are installed
on
the
bracket
secured on the frame
by
means of
welding
The
upper
and lower links
swing
through
screw
bushing
and
rubber
bushing respectively
Top
and bottom of
the
knuckle
spindle
support
are
installed
respectively
through
rubber
bushing
on
upper
link and screw
bushing
on lower
link
The
tension
rod
is
installed on the lower link The
tension
rod
receives
a force
applied
to the front
and
rear
directions
The front
end
of
the
torsion
bar
spring
is installed
on
the
torque
arm
by
means of
serration
and the
torque
arm
is installed on the lower
link
The
rear end
is connected
to
the
spring
anchor
by means of
serration
and
is
set
stationarily
on
the anchor arm member
The shock absorber is of
a
hydraulic
double
acting
type
The shock absorber installed between the
lower
link
and
the
bracket to absorb vertical vibration In addition
two
bamper
rubbers are installed on the frame
through
the bracket
limiting
link
operating ranges
In relation to the above described standard
parts
a
stabilizer is also available as an
optional
part
FRONT
SUSPENSION
Removal
I
Jack
up
vehicle
and
support
it with
stands
2
Remove hub
nuts and wheel
3
Remove front
axle
See
Section
FA Front
Axle
5
Remove anchor bolt after
loosening
lock and
adjust
nuts
using
a
jack
under
spring anchor
FA 10
Spring
anchor
Torsion bar
spring
3
Anchor bolt
Fig
FA 14
Removing
anchor bolt
6
Spring
anchor torsion bar
spring
and stabilizer
I Jack down
slowly
and remove
spring
anchor
and
torsion bar
spring
toward
rear
2
When
stabilizer
is
used
remove
bolt
securing
stabi
lizer bracket to frame Then
remove
stabilizer from
lower
link
7
Detach shock absorber
by removing
upper
and lower
nuts
Fig
FA 15 Shock absorber