User Manual

3: Operation
RT7000-MSOP 3-23
3. Press C and enter the channel from which to call. Select the appropriate
channel on the transceiver.
4. Press CALL/SEND to initiate the call.
Display: Tx ADDR xxx
5. Enter the Selcall code of the transceiver to call (001-255). A call to all
channels (Allcall) is code 000.
6. Press CALL/SEND again. The RT7000 begins the call sequence. If the
call is successful, a link alarm sounds.
Display: SC LINK
If the call is unsuccessful, calling discontinues and NO LINK is briefly
displayed.
Transcall To start a Transcall, place the RT7000 in scan mode.
1. Turn the FUNCTION knob until the TCSC icon flashes.
2. Press STATUS to turn the option ON.
3. Press SCAN.
4. Press CALL/SEND to initiate the call.
5. Enter the Transcall code of the transceiver to call (001-255). A call to all
channels (Allcall) is code 000.
6. Press CALL/SEND again. The RT7000 is now under full control of the
Transcall circuit.
The RT7000 starts transmission on each of the ten channels until it is
synchronized with the station to call. When synchronized, both
transceivers step through each channel by making a short transmission
until the best available channel is reached. Once the best channel is
reached, the RT7000 sounds an alarm indicating a successful Transcall
connection.
Display: TC LINK
If the call is unsuccessful, calling discontinues and NO LINK is briefly
displayed.
7. To break the connection, press SCAN.
8. To stop the call before connecting, press CALL/SEND.
Note: When scanning in Transcall, the receiving station also responds to a
valid Selcall.