User Manual

3: Operation
3-22 RT7000-MSOP
If you press CALL/SEND immediately after the message is sent, the call
terminates and CALL TERM is displayed.
11. To initiate an ALE call to the last station with an established link, press
CALL/SEND.
Before attempting another call, terminate the previous link.
Note: If the link quality on a THIS IS call is poor, press CALL/SEND imme-
diately to end it. Press CALL/SEND again and select RE-LINK. Press
CALL/SEND a third time and the RT7000 attempts the link again
using the second best channel. Repeat this for subsequent channels
until the link quality is acceptable.
Placing a TransAdapt, Transcall or Selcall
The RT7000 is capable of supporting the following selective call systems:
TransAdapt (TA), Selcall (SC) and Transcall (TC). Selcall is the basic, single-
channel calling system. Transcall is a more advanced system that determines
the best channel in a scan group for communications. TransAdapt is a faster
system that determines if the selected channel is acceptable for voice-quality
communications, not necessarily the best.
Call Setup Before you initiate a call, turn on the appropriate option as follows:
1. Turn the FUNCTION knob until the correct icon flashes (TCSC or TA).
2. Press STATUS to turn the option ON.
You can only select one call system at a time; you cannot turn the TCSC
option on until the TA option is off.
Before initiating TCSC operations, you must assign the RT7000 a call code
(001 to 225). This is the call code that other stations use to contact your
transceiver.
1. Press ALPHA 13.
2. Press E.
Display: TA/TC/SC
Rx ADDR xxx
3. Enter the receive call code and press E. The number must be from 001 to
255 and not assigned to another transceiver.
Display: xxx (briefly shows the new receive code)
Selcall To start a Selcall, set the RT7000 to a fixed channel (not scanning).
1. Turn the FUNCTION knob until the TCSC icon flashes.
2. Press STATUS to turn the option ON.