User's Manual

10. Scroll down to the RF Power screen and set LO PWR to 0.5W and HI PWR to .5W .
11. Scroll down to the next screen. Press < ENT > to accept the channel
settings.
12. Press < ESC > several times to get back to the operating screen. The new channel is ready to use.
To simplify programming, assume the following defaults unless told otherwise by the person
assigning channel settings:
• RX Frequency must always be specified
• TX Frequency must always be specified (unless RX Only)
• TAG is any 8 character alphanumeric value
• ID is internal radio information and cannot be changed
• If using a repeater, a Transmit CTCSS, DCS, or NAC code must be assigned.
Refer to the following tables that describe the different settings for analog and digital channels,
respectively.
Analog Settings
Setting Value Description
ID
User ID Software assigned identifier.
TAG
Name User defined channel name.