Specifications

Aestiva
4-14 1006-0939-000
4-14
Do these steps in the opposite order to assemble the bellows. If you see a dust-like
powder on the housing or the bellows, apply a thin layer of KRYTOX lubricant to the ribs
of the bellows housing. Make sure the lubricant is applied smoothly and there are no
lumps.
Make sure that:
• The arrow on the seal points up.
• You hear a double click when you install the rim.
• The rim is locked in position.
• The inner ring is correctly installed inside the top of the bellows.
• Only the bottom ring of the bellows fits over the rim.
• The housing is locked in position. You cannot lift it off.
Step 8
Push the latch towards the
center and remove the
locking tabs.
Step 9
Remove the seal.
AA.96p.035
AA.96p.036