User manual

8
Dateq XTC Manual Operation
EN
DJ-channel
This channel is designed to connect a microphone and is equipped with volume
control and a 2-way tone control. Above the gain control is a BNC-connection for an
optional 12V lamp.
GAIN (Volume preset) Determines the volume of the microphone.
TOP High tones controller.
BASS Low tones controller.
PAN Positions the microphone on every desired place between the left
and right channel. In the midposition the signal is mono, so evenly
loud on left and right.
X, T and C channel
These three channels are all equipped with double inputs, volume control, 3-way
tone control, pre fader listening and a 100 mm fader. Channel X (the left fader)
and C (the righ fader) will end up on respectively the left and right side of the
crossfader. Channel T (the middle fader) will end up directly on the master.
Line / Phono Inputselector. Normally is Line (CD, MD, tape), Pushed in is
Phono (turntable). LEDs indicate which input is selected.
GAIN Determines the pre-adjustment of the volume for both the Line
as well as the Phono input.
TOP High tones controller.
MID Middle tones controller.
BASS Low tones controller.
BAL Determines the balance between the left and the right channel.
When in mid-position, the left and right channel can be heard
evenly loud.
CUE Switches pre fader listening on and off. When this function is
active, the headphone will switch to CUE and the input signal
of one or more inputs can be heard even though the fader is
closed. A LED will indicate whether the CUE-function on this
channel is active.
FADER 100 mm fader through which the volume of this channel can be
determined precisely. The volume of channels X and C are
also dependable of the position of the crossfader.