User manual

6
Installation DATEQ SPL-D3 manual
UK
Installation
The SPL-D3 is installed apart from the audio source (a mixing desk for example) and the speakers
and amplifier.
After installation and calibrating the SPL-D3, the SPL-D3 will show all measured values in green,
orange or red within +/-1,5dB.
Connections
Microphone input; XLR 3-pin female
Pin Function Description
1 Ground Audio ground
2 Audio + Supply and audio
3 Audio - Supply and audio
Table 1: microphone connections
USB port; USB-B female
Pin Function Description
1 VCC + Supply
2 Data – Data
3 Data + Data
4 GND Ground
Table 2: USB connections
Network port; RJ45 female
Pin Function Description
1 TX-D + Data
2 TX-D – Data
3 RX-D + Data
4 Not in use
5 Not in use
6 RX-D – Data
7 Not in use
8 Not in use
Table 3: Network connections
Image 1: Installing the SPL-D3