Operation Manual

EN
Operation Dateq Ace Manual
11
PHANTOM-POWER
For each microphone-channel the phantom-power can be switched on,- or off.
To do this the cover has to be removed. On the PCB a jumper can be found with the text phantome
+24V. By placing the jumper on the lower two pins the phantompower is activated. When the
jumper is places on the upper two pins the phantompower is disabled.
As a default the phantom power is disabled for all microphones.
T
ALKOVER THRESHOLD
The TalkOver threshold can be adjusted with an internal trimmer. To do this the cover has to be
removed. The trimmer is situated at the fourth microphone channel. Below the equaliser trimmers
an additional trimmer can be found.
With a small screwdriver the level can be adjusted. By speaking in the microphone the level can be
tested.