Specifications

Strata eManager ®
Strata CIX Programming Vol.1 05/08 2-45
Strata eManager ®
Set up Modem Connection (Optional)
Step 1: Connect eManager PC to Strata CIX Modem
Connect an RJ11 cable from your PC modem to an active phone line or to a RSTU or LSLU port. See
Figure 2-3.
Figure 2-3 Strata eManager Modem Interface Connection
Step 2: Programming and Operation
The modem connection can be established one of two ways; Direct ring or Transfer.
• Direct ring connection over CO lines
– Advanced Configuration > Trunk > DID lines: assign “Built-in Modem” as the Audio Day1, Day, and/
or Night destination type.
– Advanced Configuration > Trunk > Assignments > DIT ground/loop start lines: assign “Built-in
Modem” as the Day1, Day2, and/or Night destination type.
– When connected to RSTU, ASTU or LSLI or DISA line: put “#19” in Strata eManager Phone Number
dial string.
• Transfer an eManager call to the Strata CIX modem from a CIX Auto Attendant or telephone.
– After receiving the call from the eManager user press Cnf/Trn or hookflash and dial #19, then hang
up after receiving CIX modem tone.
Note If calling an Auto Attendant put “xxxxxxx,,,,,,,, #19” in the eManager Phone Number dial string,
where “xxxxxxx” is the site phone number and each “,” adds a three-second delay before dialing
#19 to connect to the modem.
Modem
CIX
Analog Circuit
Processor
CO Line
Circuit
Dial #19
CO Line
Modem
Modem
CO Line
Telephone
Network
Remote eManager
Local eManager