Specifications
Trunks
Strata CIX Programming 05/08 6-9
Trunks
06 Start Method Enter the Start Method. This setting defines the start protocol method used
between the PSTN and this trunk (for DID/Tie trunks).
Possible values:Immediate Start (default), Timing Start or Wink Start
07 Release Supervision Enable Release Supervision from the CO.
Possible values:Received or Not Received (default)
Note
When assigning CAMA trunks for E911 (R2.22 MH232 and later, or M3.10 MK024
and later systems) set this to Enabled.
08 Answer Supervision Enable Answer Supervision from the CO.
Possible values:Received or Not Received (default)
Note
When assigning CAMA trunks for E911 (R2.22 MH232 and later, or M3.10 MK024
and later systems) set this to Enabled.
09 Trunk Name Enter the trunk name.
Possible values:Up to 14 ASCII characters (default = no value)
10 External Ring Repeat This option determines what ring signal is sent to telephones when a line rings
the telephone. Select Supplied (CO Ring Repeat) to use the ring signal supplied
by the CO or Centrex line. Select Not Supplied (CIX Ring) to use the standard
ring signal supplied by the CIX.
Important!
Ring Not Supplied must be used on all DISA lines for proper ringing
operation.
Possible values:Supplied (CO Repeat) - (default) or Not Supplied (CIX Ring)
11 DTMF Back Tone Select DTMF Back Tone type.
Possible values:Padded, DTMF Tone (default) or No Tone
12 Hunt Order The order, within the trunks OLG, in which the trunk will be seized for outgoing
calls.
Enter 1 for the first trunk seized, 2=next trunk, etc. Enter 999 for the last trunk to
be seized.
Possible values:1~264 or Last One (default = 1)
13 Immediate Cut-
Through
This option should be enabled on a line only if the talk-path must be established
immediately after seizing a selected outgoing line.
Example, a line connected to a Central Office Ringdown circuit.
Possible values:Enable, Disable (default)
CAUTION! This option will bypass Destination Restriction and E911 digit
analysis. Do not enable this option on a line where these
functions are required.
This option is available only on ground and loop, analog or T1 circuits. It should
not be enabled for Tie, DID, ISDN and StrataNet lines.
14 CO Line Guard Time The interval between the release of a CO line and its eligibility to be seized again.
F
IELD DESCRIPTION