User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Appendix – Troubleshooting and Specifications
Troubleshooting
60 Strata DKT2104-CT Cordless Digital Telephone 01/02
Table 6 Troubleshooting Suggestions
Condition Suggestion
CHARGE LED does not light when
handset is placed on Base Unit.
Make sure the AC adapter is plugged into the Charger Unit
and wall outlet. If the AC adapter is plugged into a wall outlet
with a switch, make sure the switch is turned on.
Make sure the handset is properly seated in the Charger
Unit.
Make sure the Sealed Lead-acid battery is properly seated in
the handset.
Make sure that the charging contacts on the handset and
Charger Unit are clean.
Conversation is interrupted frequently.
Make sure that the Base Unit antenna is fully vertical.
Move closer to the Base Unit.
Echo during conversation.
Depending on the environment from which you are calling,
such as a noisy area, a caller using a DKT may experience
echo if the volume control of the handset is set at 10 or
higher. You can lower the volume using ▼ or contact your
authorized dealer for handset software upgrade.
No dial tone. Move closer to the Base Unit.
Cannot configure the handset.
Check all telephone cables and lines for good connections.
Make sure the AC adapter is plugged into the Base Unit and
wall outlet.
Handset does not ring.
The Sealed Lead-acid battery could be weak. Charge the
battery for 8-10 hours.
Check the ringer - it could be turned off.
Make sure the Base Unit antenna is fully vertical.
Move closer to the Base Unit.
Tone noise. Move the handset to the right of the DKT.
Other. Contact your System Administrator.