User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Features
Held Calls
44 Strata DKT2104-CT Cordless Digital Telephone 01/02
Placing Line Appearances or [DN] Calls on Hold
➤ Press +2/'.
The Line or [DN] LED flashes green at the on-hold rate.
You hear recall tone when your station is idle (or two times only when busy) if you
do not retrieve the held call before “Hold the recall” time set in system
programming expires.
Retrieving Held Calls
➤ Press /LQH or the [DN] that is on hold.
The Line or [DN] LED flashes at the on-
hold rate.
Using Automatic Hold
Automatic Hold enables you to place a call on hold by pressing another /LQH or [DN].
You do not have to press
+2/'. You can also switch between a new and the original
call without having to press
+2/'. Automatic Hold is assigned on a station-by-
station basis in system programming.
➤ Press another /LQH or [DN] to receive or originate a new call, while on one call.
The original Line or [DN] LED flashes at the on-hold rate and the original call is
placed on hold.
The LED of the new call lights steady and the new line is accessed.
Switching Between Calls
➤ Press /LQH or [DN] of the held call.
The Line or [DN] LED just placed on hold flashes at the on-hold rate, and the LED
of the Line just accessed lights steady.
HOLD
NO. 6753
talk