User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Features
Call Waiting
Strata DKT2104-CT Cordless Digital Telephone 01/02 39
Call Waiting
Call Waiting places an incoming call in queue and alerts you with a warning tone. The
[DN] or Line LED flashes at the on-hold rate.
1. If you are talking, press
+2/'
...or the flashing [DN]. The call you are on is placed on hold and you are connected
to the waiting call. The [DN] or Line LED lights steady.
...or
/LQH if your telephone has the Auto Hold feature. See your System
Administrator to find out if you have Auto Hold.
...or the ringing [DN] or
/LQH.This disconnects the current call and then connects
you to the transferred call. The [DN] or Line LED remains steady.
...or
WDON. The existing call is disconnected. The camped-on line rings your
telephone and the Line LED flashes at the incoming call rate.
2. Press a [DN], then
/LQH
...or WDON again.
Direct Station Selection Buttons (Hotline)
This optional feature enables you to use a '66 button to connect directly to another
station’s line extension. The DSS LED shows the status (idle/busy) of the station and/
or the station’s primary extension. For example, a station’s DSS button LED shows
busy (light steady red) when the station is:
• busy on a call on any button
• idle but all appearances of the station’s extension are in use by other stations.
When the station is in DND, the LED flashes red.
➤ To connect directly to another station’s extension
1. When connected to a line or another station, press
'66.
The original party is put on-hold. You can call a station even if the DSS LED
shows busy (steady red).
2. Announce the call...or transfer the call by hanging up or pressing
5HOHDVH.
Note You can transfer the call to an idle or busy station.