User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Features
Call Park Orbits
36 Strata DKT2104-CT Cordless Digital Telephone 01/02
Call Park Orbits
The Call Park feature enables you to hold a call temporarily in a location other than
your telephone. These areas are called orbits. You or another telephone user can
retrieve a parked call from its orbit by specifying the orbit number. You can specify
one of 20 General Park Orbits (7000~7019) or a valid extension number within the
system.
Once you have parked a call in an orbit, you can:
• Hang up and retrieve the parked call at a later time
• Originate another call
• Access a voice paging device to announce the parked call for pickup from another
station
If you park a call and it is not retrieved, it will recall to the parking station and one of
the following occurs:
• If your station is idle when the system Call Park recall timer expires, the parked
call automatically recalls to your station.
• If your station is busy, the parked call camps on.
If you have an LCD telephone, you can let the system automatically select an
available orbit number which displays on your LCD.
➤ To park a call
1. While on a call, press
3DUNLQ2UELW
...or &1)751 + . The LED flashes green (consultation-hold).
2. Specify the Park Orbit using one of the following:
• Press
and the system automatically selects a General Park Orbit between
~. The chosen orbit appears on the LCD.
• Enter a valid extension.
• Press
and the system automatically selects your extension as the orbit.
3. Hang up. The caller’s extension or line number and the orbit number are shown. If
the parked call is not retrieved within a specified time, the call rings back to your
phone. When a parked call recalls your phone, the LCD shows the line or extension
that is recalling and the orbit number.