User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Handset Operation
Conference Calls
Strata DKT2104-CT Cordless Digital Telephone 01/02 25
You receive a recall ring when your station or [DN]is idle and camp-on is
cancelled when the called station user fails to answer within a predetermined time.
Repeat the procedure if necessary.
Conference Calls
You can conference together up to eight parties (including your own) - with up to six
parties being external CO or network lines. The actual number of conference parties
with acceptable volume levels depends on the local and far end phone line conditions.
The person who initiates the conference call is the Master. If, after the conference is
established and the Master exits the conference, the first station to have been added to
the conference becomes the Master.
➤ To conference calls
1. While on a call, press
&1)751. You hear dial tone. The Line LED flashes green.
2. Call another station or outside line.
3. When the called party answers, press
&1)751. If you receive a busy tone or no
answer, press
&1)751 again to return to the original connection. All parties are
conferenced. If the second call was placed on a
/LQH that appears on your phone,
the LED also flashes green.
4. Repeat the above steps to add lines to the conference. Keep in mind the maximum
number of allowed conference parties.
Note When the “master” of the conference hangs up, the control is automatically
transferred to the first internal station added to the conference call. If no other
internal stations are included in the conference call, the call is disconnected.
➤ To transfer conference control
1. Do Steps 1 and 2 above to add the line to which you wish to transfer conference
control. See previous Note.
2. Announce the call and hang up to transfer the call. This station now becomes the
conference “master” with the ability to add or delete parties.
➤ To hold a conference call
➤ If you are the Conference Master, press the +ROG key once (or twice for Executive
Hold) to place the conference call on hold. The other parties can continue with the
conference. Music-on-hold is suppressed and your extension LED flashes green.
You can rejoin the conference at any time by pressing your extension LED. When
you return, you retain Master status.