User guide

Handset Operation
Transferring Calls
24 Strata DKT2104-CT Cordless Digital Telephone 01/02
Transfer Calls to the Cordless
You can transfer an active call from the DKT to the cordless or vice versa by using
+2/'. If the cordless is idle, the transfer takes place immediately.
1. While in conversation, press
+2/' on the DKT. The Line
LED flashes.
2. Press
WDON on the Cordless handset The Cordless LED lights
steady. The DKT LEDs go out and displays “CORDLESS
MODE.”.
3. Press
+2/' on the Cordless handset (shown right).
Transfer Calls to the DKT
1. Press +2/' on the cordless handset.
2. Pick up the DKT telephone and press the flashing Line LED.
Using Camp-on
1. Press&1)751. You hear dial tone and the Line or [DN] LED flashes at the
conference rate.
2. Enter the destination [DN], Hunt Group number, or ACD group [DN]. You hear a
single tone.
Note If the call was made with Tone Signaling instead of Voice First Signaling, you
hear ringing tone.
3. When the [DN] answers, announce the call. If the called station does not answer,
you receive a recall ring (when your station or
[DN] is idle). The ring is set by
system programming.
4. Press
WDON. The Line LED changes to steady when the called station connects with
the transferred call.
...or
/LQH, [DN] +  to reconnect to the transferred line before the call is
answered or busy tone is received.
The Line LED changes to steady red when the called station connects with the
transferred call. After you hang up, the Line LED begins to flash at the on-hold rate
or if you transferred the call from a [DN], the [DN] LED goes out. The CO Line or
[DN] camps onto the called station and the called station receives a warning tone.
4505