User guide

Handset Operation
Transferring Calls
Strata DKT2104-CT Cordless Digital Telephone 01/02 23
Transferring Calls
You can transfer calls to a idle or busy station, but you cannot transfer calls to a station
that is in the DND mode.
Note You cannot transfer calls to a station that is DND.
1. Press
&1)751. You hear dial tone and the Line or [DN] LED flashes at the
conference rate.
2. Enter the transfer-to [DN], Hunt Group [DN], or ACD group [DN]. You hear a
single tone, unless the call was made with Tone First Signaling. Then, you hear
ringing tone.
3. Announce the call. The Line LED changes to steady red when the called station
connects with the transferred call. If the called station does not answer, you receive
a recall ring. Your station or
[DN] must be idle to receive the recall.
...or press
/LQH, [DN] +  to reconnect to the transferred call before the called
party answers or busy tone is received. After you hang up, the Line LED begins an
on-hold flash, or the [DN] LED goes out if you transferred the call from a [DN].
4. Press
WDON. The Line LED changes to steady when the called station connects with
the transferred call.
Answering a Transferred Call
➤ Press WDON
...or the flashing [DN]. The [DN] or Line LED is steady when you connect to the
call.
➤ To transfer a call directly to Voice Mail (VM)
1. While on a call, press
&1)751.
2. Enter
.
3. Enter the VM mailbox number (usually the same as the extension number) +
.
4. Hang up and the caller is connected to the VM mailbox. This feature does a blind
transfer to VM.