User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Handset Operation
Switching Cordless and DKT Modes
18 Strata DKT2104-CT Cordless Digital Telephone 01/02
Switching Cordless and DKT Modes
➤ To set the cordless mode
1. Pick up the handset and press
WDON. This message blinks, and you hear dial tone.
The Cordless LCD shows
ACQUIRING LINK. The DKT
displays
CORDLESS MODE.
2. Press
WDON again and return the handset to the Charger
Unit. This displays on the handset and the DKT LCD.
Note The handset LCD goes blank after a few seconds.
...or clip it to your belt.
➤ To set DKT mode
➤ Pick up the DKT telephone. You hear dial tone. This
displays on the handset and the DKT LCD.
Tone or Voice First Signaling
If you are a new user of the cordless digital telephone, ask your System Administrator
if the Strata CTX system has Tone or Voice First Signaling. Tone Signaling rings and
Voice First has a long tone followed by the caller’s voice. You can toggle between
Tone and Voice First Signaling on a call-by-call basis.
Both signals are enabled in system programming and determine how you make and
answer calls.
➤ To change the signaling
1. Press [DN] + station [DN]. If Tone First Signaling is enabled, you hear a one-
second ring every four seconds. If Voice First Signal is enabled, you hear a tone
burst.
2. Press
. The other signaling is activated.
➤ To answer a Tone First Signaling call
➤ Press WDON. You hear successive ring tones.
talk
NO. 6700
APR14WED10: 20