User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Strata DKT2104-CT Cordless Digital Telephone 01/02 15
Configuration 3
This chapter shows you how to configure the DKT2104-CT. It can operate as a DKT
or cordless telephone and be programmed whenever it is idle. When entering the
program mode, all incoming calls are identified with a ringback tone until the program
mode is ended and current calls are unaffected.
You can configure three settings that affect the way the cordless telephone operates
with the Strata CTX system that are:
• PROG1 – reserved
• PROG2 – reserved
• RCV LEVEL – F3 (On) sets the receive level to normal; F3 (Off) sets the receive
level to 4-dB level (level).
These settings default to On.
Enter the Program Mode
1. Remove the handset from the Charger Unit.
2. Press and hold
and
at the same time (shown at right).
3.
Press YRO to step forward and back through the menu.
5
03