User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Installation
Step 9: Install Headset (Optional)
14 Strata DKT2104-CT Cordless Digital Telephone 01/02
Step 9: Install Headset (Optional)
The optional headset provides a hands-free option because you can use the belt clip to
carry the handset and conduct a conversation. All feature operations remain the same
except the handset earphone and microphone are disconnected.
➤ Open the cover over the headset jack that is located on
the side of the handset and plug in the headset as
shown at right..
Important! Only use headsets especially designed or
modified for use with radio frequency
equipment.
Step 10: Install Belt Clip
Note The belt clip is designed to fit snugly onto the handset.
1. Remove the belt clip tab from the top rear of the handset
(shown at right).
2. Slide the belt clip into the space where the belt clip tab was,
carefully aligning the belt clip sides to the notches.
3. Use the belt clip to attach the handset to your belt or pocket.
➤ To remove the belt clip
1. Pull the belt clip release button back (shown at right).
2. Carefully lift the belt clip off.
4509
4385
4508
Apply
Pressure
Push