User guide
Table Of Contents
- Title Page
- Publication Information
- TAIS TSD License Agreement
- TAIS TSD Limited Warranty
- Contents
- Introduction
- Chapter 1 - The Grand Tour
- Chapter 2 - Installation
- Step 1: Review Safety Instructions
- Step 2: Select Location
- Step 3: Mount on a Wall
- Step 4: Connect Telephone Cables
- Step 5: Connect and Apply Power
- Step 6: Raise the Base Unit Antenna
- Step 7: Install Handset Battery
- Step 8: Charge Batteries for First Time
- Step 9: Install Headset (Optional)
- Step 10: Install Belt Clip
- Chapter 3 - Configuration
- Chapter 4 - Handset Operation
- Chapter 5 - Features
- Account Code Calls
- Automatic Busy Redial
- Automatic Callback
- Auto Redial
- Call Forward
- Call Park Orbits
- Call Waiting
- Direct Station Selection Buttons (Hotline)
- Do Not Disturb
- Door Lock(s)
- Door Phone(s)
- Emergency Ringdown
- Held Calls
- ISDN Outgoing Calling
- Message Waiting
- Off-hook Call Announce
- Override Calls
- Paging
- Privacy
- Redial
- Release and Answer
- Speed Dial
- Tone/Pulse Dialing
- Voice Mail - Direct Transfer
- Appendix A - Feature Access Codes
- Appendix B - Troubleshooting and Specifications
- Index
Installation
Step 2: Select Location
10 Strata DKT2104-CT Cordless Digital Telephone 01/02
Step 2: Select Location
1. Select a location that is not subject to excessive heat or humidity.
2. Determine if the Base Unit will sit on your desk or be wall mounted. If wall
mounted, go to Step 3: “Mount on a Wall”.
3. Place the Base Unit on a desk or tabletop near a standard 120VAC outlet and
within reach of the Strata CTX digital line connection.
4. Keep the Base Unit and handset away from sources of electrical noise, such as
motors and fluorescent lighting.
Important! Place the Base Unit to the right of the DKT. If placed on the left, the
cordless antenna picks up a tone due to its close proximity to the DKT
speaker and electronic parts.
Step 3: Mount on a Wall
1. Select a wall location near a 120VAC outlet and within reach of the Strata CTX
digital line connection.
2. Place the wall plate (shown at right) against
the wall, and with a pencil, mark the position
of the screws.
3. With a punch tool, punch “starter” holes in the
wall.
4. Align the wall plate and screws on the wall
where the “starter” holes are and tighten down
the screws.
4449