User's Manual

Left Handle Slider Bar
Moving the Left Analogue stick left and right will adjust the Left Handle Slider Bar, as shown in
the following illustration:
Once you are happy with your configuration press the Start button to save the configuration. As
detailed under section ‘11’ you can now activate the feature with your chosen configuration.
13. EVO Customizer PC software
The EVO Customizer is a free downloadable PC application which allows you to download and
configure the TurboFire EVO Features. The EVO Customizer is downloadable complete with
instructions from Datel’s website, www.codejunkies.com.
Using the EVO Customizer and the USB Cable (supplied), you can choose from a host of
downloadable features including Combo Sequences, Y-Axis Reverse, Analogue Sensitivity, Left
Handed Mode, Auto Fire and Custom Image. You can also download the pre-installed features
Sniper, Remap, Rapid Fire and Low recoil.
As explained in this user guide for the pre-installed features, you can configure features using
the Combat Command LCD Display. In addition to this it is possible to configure each of the
available features using the EVO Customizer.
This fantastic feature gives you the ultimate freedom to customize the TurboFire EVO for how
you want to play and best of all it is completely free.
14. FCC Rules, Part 15
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
x This device may not cause harmful interference.
x This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Responsible Party:
Datel Design & Development Inc,
33 North Garden Avenue,
Suite 900,
Clearwater,
FL 33755
United States of America
Tel. [phone]