User's Manual

12. Pre-installed Features
The TurboFire EVO is preinstalled with the features Sniper, Remap, Rapid Fire and Low recoil.
Each of the pre-installed features is easily identifiable by the following feature images:
12.1. Sniper
The TurboFire EVO controller is equipped with a unique programmable Sniper Mode feature
which allows for you to slow down the movement of either analogue stick. In slowing down the
movement of either analogue stick allows for more precise movements, which is an advantage
when playing in a sniper situation which requires accurate aiming.
After entering the TurboFire EVO Menu as detailed under section ‘10’, using the button
select the Sniper feature image to enter the Sniper configuration screen. If you would like to
return to the TurboFire EVO Menu at any time press the Back button.
12.1.1. Configuring Sniper
When configuring Sniper you are increasing or decreasing the speed of the analogue sticks by
adjusting the y-axis and x-axis slider bars for each analogue sticks. The y-axis is up and down
movement, the x-axis is left and right movement. The centre of a slider bar represents the
normal speed of the axis. When moving a slider bar to the left you are slowing down the x-axis
or y-axis. When moving a slider to the right you are speeding up the x-axis or y-axis.
In order to adjust each of the slider bars you need to scroll up or down to highlight the slider
bar which you would like to adjust. Whilst highlighting the chosen slider bar move each of the
sliders left or right. You can use any of the buttons shown in the following illustration:
Once you are happy with your configuration press the Start button to save the configuration. As
detailed under section ‘11’ you can now activate the feature with your chosen configuration.
12.2. Remap
Button remapping gives you the ultimate control
over the
TurboFire EVO layout by allowing you to
choose which buttons should be pressed to activate
each control.
After entering the
TurboFire
EVO Menu as detailed
under section ‘10’, using the
button select the
Remap image to enter the Remap configuration
screen. If you would to return to the
TurboFire
EVO
Menu at any time press the Back button. As shown
in the following illustration, the Remap
configuration screen displays which buttons are
assigned to each of the controls.