User`s manual

User’s Manual

PRECAUTIONS FOR INSTALLATION

— Do not use or store the equipment in a place exposed to fire, moisture, or

direct sunshine, or in a place near a heater or thermal device where the pre-

scribed operating temperature and humidity are not met, or in a place exposed to

much oil, iron powder, or dust. The equipment may become out of order, emit

smoke, or catch fire.

— Do not install or use the equipment in a place like a laboratory where chemical

reactions are expected, or in a place where salt or gases are contained in the

air. There is a danger of fire or electric shock.

— Install the printer on a flat, stable desk or table that is free from vibration, in a

well-ventilated place.

— Do not install the printer at a location where its operation could be hindered.

— Do not place anything on the printer or leave small objects, like a clip or pin,

around it. A foreign object could cause trouble if it gets inside.

— Do not use any sharp-pointed object, such as a pen, for example, to touch the

operation panel of the printer. It could cause trouble.

— Do not use the equipment near a radio or TV receiver. Do not share the power

from a plug socket a radio or TV receiver is connected to. It may cause a

reception problem.

— Use the equipment only at the specified power supply, voltage and frequency.

Otherwise, it may emit smoke and catch fire or cause other problems.

— Connect only the specified power source. Use of an unspecified power

source could cause trouble or smoke/fire.

— Confirm that a plug socket used for connection has sufficient capacity.

— Avoid connecting a power cable to a plug socket shared by other devices or

extending the wiring too far. It may result in the cable catching fire or a power

outage. Also, do not step on or apply an excessive force (Pull, Load) to the

cable, and do not use the printer with such a force applied to it.

— Never connect a grounding cable (Frame ground) to a gas pipe. There is a

danger of explosion. When connecting or disconnecting the grounding cable,be

sure to disconnect the power cable and the power plug from the plug socket.

— When connecting/disconnecting the cables, be sure to turn off the power

first, including the connected side, and then connect/disconnect them, holding a

plug and a connector. Pulling the cable itself could cause it to snap or become

damaged.

— Connect a power cable or a connector cable securely. If a reverse-polarity

connection is a made, internal elements may be broken or a mating device

may be ad versely affected.