User`s manual

1 DATECS LP-50

4.5 LEDs

POWER Lights green when the printer is switched on.

ERROR Flashes red when the printing head is overheated.

PAPER Flashes red when the printer is out of paper, lights red constantly

if the paper is put, but the lever is not pushed down.

4.6 FEED Switch Function

Pressing this button feeds the paper until it is released.

The button must be pressed to continue printing after out of paper error.

If a manual macro execution is selected the button must be pressed for

each macro execution.

Holding down the button while the printer is switched on prints the self

test when the button is released.

4.7 Paper End Function

After replacing the paper the printer will resume printing after the Line Feed

buttons pressed once. Replace the paper according to “4.3 Inserting the Paper.”

4.8 How to Remove Remaining Paper Roll

1 Remove the printer cover.

2 Raiser the head-up lever.

3 Gently pull out the paper to the near side. If the paper roll is still remaining,

cut it just before the paper insertion slot before pulling it out.

CAUTION

—Do not pull out the paper roll in the opposite direction.

—Never take out paper with the head-up lever lowered, because it could

damage the printing head.

—The printer mechanism may be very hot just after printing, so be duly careful.