User`s manual

21
User’s Manual
4.2 Connecting Interface Cable
1 Turn off the power. (Mating side included)
2 Check the top and bottom of cable terminals, and connect to the interface
connector.
3 Connect the cable to the host computer.
4.3 Inserting the Paper
!
CAUTION
1 Hold the convexity on the rear of the printer cover, and raise it upward.
2 Cut the front end of the paper roll almost at a right angle.
3 Make sure that the power is turned on.
4 Pull the head-up level to this side to raise up the printing head.
5 If there is still some paper remaining after a paper-out indication, eliminate
the paper roll according to “4.8 How to Remove Remaining Paper Roll.”
6 Insert the front end of the paper roll straight into a paper insertion slot.
7 Set the paper roll firmly in the paper holder.
8 Put back the head-up lever. The paper roll is automatically puiied in by the platen
roller to feed a constant amount of paper. (When auto-loading is enabled.)
9 Put back the printer cover.
— Be sure to use the specified paper roll.
— Use of non-specified peper may not guarantee the print quality, printing
head life, and so on.