User`s manual

1 DATECS EP-50
10 11
User’s Manual
PRECAUTIONS FOR HANDLING
Do not handle the equipment in the following manners, because problems
may result.
y Do not use any other power source besides the accessory AC adapter. Also,
do not use the AC adapter for other purposes.
y Do not print without paper.
y Do not drop or put any foreign object, such as a clip, pin, or the like, inside the
printer.
y Do not spill any liquid or spray any chemical-containing liquid over the
equipment.
y Never use a pointed object, such as a pen, to operate the operation panel.
y Do not use Scotch tape to fasten paper together for continuous use. It could
damage the printing head.
y Never pull the set paper forcibly. When opening/closing the printer cover,
take care that the paper will not be caught. It could cause the paper to jam.
y Be sure to use the specified paper. Use of other paper could deteriorate the
print quality or cause a problem with the printing head.
To Prevent and Spreading of Damage
y Never touch the printing head motor, or paper cutting blade. Your finger may
be cut.
y During power-on or immediately after printing, do not touch electrical parts or
moving parts, such as the mechanism, motor, internal dear, etc. They may be
very hot and can burn your hand/finger.
y Be careful to avoid bodily injure or damaging other objects with an edge of
sheet metal.
y Should any error occur while operating the equipment, stop it immediately
and disconnect the power plug from the plug socket.
y Only a qualified serviceman is allowed to disassemble or repair the printer.
y Should a problem occur, leave solving it to our serviceman. Do not
disassemble the equipment on your own.
y When opening/closing the printer cover, and so on, be careful not to catch
your hand or finger on the equipment.
y After using the equipment, turn off the power switch and unplug the AC
adapter from a plug socket.
y Use a shielding wire or twisted pair wire for a signal line, in order to minimize
noise effect. Do not route the cable too long or connect it to a noisy device.
Connection to a noisy device could cause erroneous printing due to corrupt
data, and so on.
y Use the equipment in an environment where there is s plug socket near the
main body and you can easily disconnect the power plug from it, to shut off the
power.
y When the equipment will not be used for a long period of time, unplug it and
remove the paper roll from it.
y When transporting the equipment, remove the paper roll from paper holder.
!